The battery of the total station is one of the most important components of the total station. The batteries equipped in the total station are generally Ni MH (nickel hydrogen battery) and Ni Cd (nickel cadmium battery). The quality of the battery and the amount of electricity determine the length of field work time.
1. It is recommended not to remove the battery when the power is turned on, because the stored data may be lost at this time, so please load or remove the battery after the power is turned off.
2. Rechargeable batteries can be recharged and used repeatedly, but if they are charged when the battery still has residual power, the working time of the battery will be shortened. At this time, the voltage of the battery can be restored by refreshing, so as to improve the working time. The discharge time of fully charged batteries takes about 8 hours.
3. Do not charge or discharge continuously, otherwise the battery and charger will be damaged. If it is necessary to charge or discharge, the charger should be used after stopping charging for about 30 minutes.
4. Do not charge or discharge the battery just after charging. Sometimes this will cause battery damage.
5. Exceeding the specified charging time will shorten the service life of the battery, which should be avoided as far as possible
6. The display level of battery residual capacity is related to the current measurement mode. In the angle measurement mode, the battery residual capacity is sufficient, which can not guarantee that the battery can also be used in the distance measurement mode, because the power consumption of the distance measurement mode is higher than that of the angle measurement mode. When switching from the angle mode to the distance mode, the ranging will be suspended from time to time due to insufficient battery capacity.